Difference between revisions of "nokia aggregate interface setup via CLI"

From cpwiki.net
Jump to: navigation, search
Check Point Profressional Services
(Created page with "set member interface parameters, then must all match clish -c "set interface eth-s4p2 duplex full" clish -c "set interface eth-s4p3 duplex full" clish -c "set interface eth...")

Revision as of 14:41, 3 July 2013

set member interface parameters, then must all match

clish -c "set interface eth-s4p2 duplex full"
clish -c "set interface eth-s4p3 duplex full"
clish -c "set interface eth-s4p4 duplex full"
clish -c "set interface eth-s4p2 speed 1000M"
clish -c "set interface eth-s4p3 speed 1000M"
clish -c "set interface eth-s4p4 speed 1000M"

add interfaces above to group (need to create group 1st?... not sure)

clish -c "add linkaggregation group 1"
clish -c "add linkaggregation group 1 port eth-s4p2 type primary"
clish -c "add linkaggregation group 1 port eth-s4p3"
clish -c "add linkaggregation group 1 port eth-s4p4"

configure aggregate interface 

clish -c "set interface ae1 active on"
clish -c "set interface ae1 duplex full"
clish -c "set interface ae1 speed 3000M"
clish -c "set interface ae1c0 logical-name ae1c0"
clish -c "add interface ae1c0 address 10.206.15.1/30"