61k CMM - Revision history

Nighthawk at 16:20, 14 January 2015

2015-01-14T16:20:37Z

Nighthawk at 16:20, 14 January 2015

2015-01-14T16:20:30Z

Nighthawk at 06:24, 11 December 2013

2013-12-11T06:24:02Z

Nighthawk: Created page with "Chassis Management Module CLI The Chassis Management Module (CMM) monitors and controls hardware modules in the chassis. Communication with a CMM occurs via SNMP requests from..."

2013-12-11T06:18:52Z

Created page with "Chassis Management Module CLI The Chassis Management Module (CMM) monitors and controls hardware modules in the chassis. Communication with a CMM occurs via SNMP requests from..."

New page

Chassis Management Module CLI
The Chassis Management Module (CMM) monitors and controls hardware modules in the chassis.
Communication with a CMM occurs via SNMP requests from the SMO SGM. If a hardware sensor reports a
problem the CMM automatically takes action or sends a report. CMMs also have a command line interface.
There are two ways to connect a CMM CLI:

Connect to the serial port on the front panel of the CMM
o
In your terminal emulation program, set the baud rate to 9600
o
Enter admin for the user name and password

Open a telnet or SSH session from one of the SGMs
o
First make sure that you have connectivity to the CMMs by pinging both
addresses:

198.51.100.33 (routed via SSM1)

198.51.100.233 (routed from SSM2)
o
Telnet or ssh from the SGM to the CMM
o
Enter admin for the user name and password

@@ Line 24: / Line 24: @@
 * Enter admin for the user name and password
- note - the information above is base on default configurations
+note - the information above is base on default configurations
 [[category:61k]]

@@ Line 23: / Line 23: @@
 * Telnet or ssh from the SGM to the CMM
 * Enter admin for the user name and password
 [[category:61k]]

@@ Line 1: / Line 1: @@
-Chassis Management Module CLI
+'''Chassis Management Module CLI'''
 The Chassis Management Module (CMM) monitors and controls hardware modules in the chassis.
 Communication with a CMM occurs via SNMP requests from the SMO SGM. If a hardware sensor reports a
 problem the CMM automatically takes action or sends a report. CMMs also have a command line interface.
-There are two ways to connect a CMM CLI:
+[[There are two ways to connect a CMM CLI:]]
-
- Connect to the serial port on the front panel of the CMM
+) Connect to the serial port on the front panel of the CMM
- In your terminal emulation program, set the baud rate to 9600
+* In your terminal emulation program, set the baud rate to 9600
+* Enter admin for the user name and password
- Enter admin for the user name and password
-
+OR
- Open a telnet or SSH session from one of the SGMs
+) Open a telnet or SSH session from one of the SGMs
- First make sure that you have connectivity to the CMMs by pinging both
+* First make sure that you have connectivity to the CMMs by pinging both
 addresses:
-
 .51.100.33 (routed via SSM1)
-
 .51.100.233 (routed from SSM2)
-−
- Telnet or ssh from the SGM to the CMM
+* Telnet or ssh from the SGM to the CMM
+* Enter admin for the user name and password
- Enter admin for the user name and password